EIGRP and OSPF

11. What are the reasons for creating OSPF in a hierarchical design?

1. To decrease routing overhead
2. To speed up convergence
3. To confine network instability to single areas of the network
4. To make configuring OSPF easier

A. 1, 2 and 3
B. 3 only
C. 3 and 4
D. 2, 3 and 4

Correct Answer: A. 1, 2 and 3

12. Which two of the following commands will place network 10.2.3.0/24 into area 0?

1. router eigrp 10
2. router ospf 10
3. network 10.0.0.0
4. network 10.2.3.0 0.0.0.255 area0
5. network 10.2.3.0 0.0.0.255 area 0

A. 1 and 4
B. 2, 4, and 5
C. 2 and 5
D. 3 and 4

Correct Answer: C. 2 and 5

13. If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?

A. The lowest IP address of any physical interface
B. The highest IP address of any physical interface
C. The lowest IP address of any logical interface
D. The highest IP address of any logical interface

Correct Answer: B. The highest IP address of any physical interface

14. Which of the following protocols support VLSM, summarization, and discontiguous networking?

1. RIPv1
2. IGRP
3. EIGRP
4. OSPF
5. BGP
6. RIPv2

A. 1 and 4
B. 2 and 5
C. 3, 4 and 6
D. All of the above

Correct Answer: C. 3, 4 and 6

15. You get a call from a network administrator who tells you that he typed the following into his router:

router

A. The wildcard mask is incorrect.
B. The OSPF area is wrong.
C. The OSPF Process ID is incorrect.
D. The AS configuration is wrong.

Correct Answer: A. The wildcard mask is incorrect.

Warning: Undefined variable $in_same_cat in /www/wwwroot/mtexam.com/public_html/wp-content/plugins/EXP.GKFEED.COM/function.php on line 27

Warning: Undefined variable $excluded_categories in /www/wwwroot/mtexam.com/public_html/wp-content/plugins/EXP.GKFEED.COM/function.php on line 27
NEXT POST >Virtual LANs

Leave A Comment?